Assembly | Sears NTL19010.0 specification

ASSEMBLY

•Assembly requires two persons.

•Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until you finish all assembly steps.

•The underside of the walking belt is coated with high-performance lubricant. After shipping, there may be some lubricant on top of the walking belt or on the shipping carton. This is normal. If there is lubricant on top of the walking belt, wipe it off with a soft cloth and a mild, non-abrasive cleaner.

•To identify small parts, see page 6.

•Assembly requires the following tools:

the included hex keys

one Phillips screwdriver

To avoid damaging parts, do not use power tools.

1. Make sure that the power cord is unplugged.	1
	1
Identify the right Upright (77), which has a wire
tie in it. Hold the Upright near the right side of
the incline trainer.
See the inset drawing. Tie the wire tie in the		Wire
right Upright (77) around the end of the Upright		Tie
Wire (78). Then, pull the other end of the wire tie
until the Upright Wire is routed out of the top of
the Upright.
		77
	Wire
	Tie	78
		78
	78	77
	7

Image 7

Sears NTL19010.0 user manual Assembly, Make sure that the power cord is unplugged, See the inset drawing. Tie the wire tie

Contents

Model No. NTL19010.0 Serial No QUESTIONS?Call TOLL-FREE Table of Contents Important Precautions Page BEFORE YOU BEGIN Part Identification Chart Make sure that the power cord is unplugged AssemblySee the inset drawing. Tie the wire tie Screws, and then tighten them. Be careful Tie Pulse Wire Console Assembly Wire Tie 101 102 103 Console Base 87. Do not overtighten Screws Right Upright 77. Make sure that no wires areStar Washers 8. Note Start the lower Screw First Washers 8. Note Start the lower Screw first Upright 77. Make sure that no wires are Screws and then tighten them Percent. Then, unplug the power cordAttach the Right Inside Cover and the Right Chest Heart Rate Monitor HOW to PUT on the Heart Rate MonitorCare and Maintenance Troubleshooting HOW to Plug in the Power Cord Operation AND ADJUSTMENT Features of the Console DiagramConsole HOW to USE the Touch Screen HOW to Turn on the Power Create an iFit Live account HOW to SET UP the CONSOLE Connect to your wireless network Check for firmware updates Calibrate the incline system HOW to USE the Manual Mode Do this, the incline trainer’s electrical compo When you are finished exercising, removePlug the power cord. Important If you do not Key from the console Select an onboard workout HOW to USE AN Onboard WorkoutStart the workout Select the main menu. See on Select a set-a-goal workout HOW to USE a SET-A-GOAL Workout Start the workout. See on HOW to USE AN Ifit Live Workout HOW to USE the Equipment Settings Mode Find Keycodes HOW to USE the Maintenance ModeExit the maintenance mode Calibrate the incline system of the incline trainer Exit the wireless network mode HOW to USE the Wireless Network ModeEnable Wi-Fi Set up and manage a wireless network connection HOW to USE the Internet Browser HOW to USE the Stereo Sound System HOW to Move the Incline Trainer Symptom The power turns off during use Troubleshooting Symptom The walking belt slows when walked on Page Exercise Frequency Exercise GuidelinesExercise Intensity Workout Guidelines Suggested Stretches Qty Description Part List Description Exploded Drawing a Exploded Drawing B 106 110 Exploded Drawing D Exploded Drawing E Limited Warranty Ordering Replacement PartsIcon Health & Fitness, Inc., 1500 S W., Logan, UT