TROUBLESHOOTING
Most incline trainer problems can be solved by fol- lowing the simple steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, see the front cover of this manual.
SYMPTOM: The power does not turn on
a.Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor is plugged into a
14. IMPORTANT: The incline trainer is not com- patible with
b.After the power cord has been plugged in, make sure that the key is inserted into the console.
c.Check the power switch located on the incline trainer frame near the power cord. If the switch protrudes as shown, the switch has tripped. To reset the power switch, wait for five minutes and then press the switch back in.
c
Tripped | Reset |
SYMPTOM: The power turns off during use
a.Check the power switch (see the drawing above). If the switch has tripped, wait for five minutes and then press the switch back in.
b.Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for five minutes, and then plug it back in.
c.Remove the key from the console, and then reinsert it.
d.If the incline trainer still will not run, please see the front cover of this manual.
SYMPTOM: The console displays remain lit when you remove the key from the console
a.The console features a display demo mode, de- signed to be used if the incline trainer is displayed in a store. If the screen remains lit when you re- move the key, the demo mode is turned on. To turn off the demo mode, see step 5 on page 23.
SYMPTOM: The console does not display speed and distance correctly
a.Remove the key from the console and UNPLUG THE POWER CORD. Next, remove the three indi- cated #8 x 1/2" Cover Screws (18) and the #8 x 1 1/4" Screw (36). Lift off the Left Roller Cover (38).
a | 36 |
| |
| 38 |
| 18 |
| 18 |
28
