Percent. Then, unplug the power cord | Sears NTL19010.0 specification

10. See page 14 and plug in the power cord. Next,	10
see page 16 and turn on the power. Then, touch	10
see page 16 and turn on the power. Then, touch
the Incline button numbered 40 on the console.		58
The Frame (58) will adjust to an incline of 40		58
percent. Then, unplug the power cord.
Identify the Left Inside Cover (110) and the Left
Outside Cover (106). Next, hold the Left Inside
Cover against the left Upright (77). Then, hold
the Left Ouside Cover against the Left Inside
Cover.
Attach the Left Outside Cover (106) to the Left	36	77
Inside Cover (110) with a #8 x 1 1/4" Screw (36)		77
and two #8 x 3/4" Screws (1). Start all three
Screws and then tighten them.		106
Attach the Right Inside Cover and the Right		106
Attach the Right Inside Cover and the Right		110
Outside Cover (not shown) as described	1	110
above.	1

11.Make sure that all parts are properly tightened before you use the incline trainer. Keep the included hex keys in a secure place. One of the hex keys is used to adjust the walking belt (see pages 29 and 30). To pro- tect the floor or carpet from damage, place a mat under the incline trainer.

12

Image 12

Sears NTL19010.0 user manual Percent. Then, unplug the power cord, Screws and then tighten them

Contents

QUESTIONS? Model No. NTL19010.0 Serial NoCall TOLL-FREE Table of Contents Important Precautions Page BEFORE YOU BEGIN Part Identification Chart Assembly Make sure that the power cord is unpluggedSee the inset drawing. Tie the wire tie Screws, and then tighten them. Be careful Tie Pulse Wire Console Assembly Wire Tie 101 102 103 Right Upright 77. Make sure that no wires are Console Base 87. Do not overtighten ScrewsStar Washers 8. Note Start the lower Screw First Upright 77. Make sure that no wires are Washers 8. Note Start the lower Screw first Percent. Then, unplug the power cord Screws and then tighten themAttach the Right Inside Cover and the Right HOW to PUT on the Heart Rate Monitor Care and MaintenanceTroubleshooting Chest Heart Rate Monitor Operation AND ADJUSTMENT HOW to Plug in the Power Cord Diagram Features of the ConsoleConsole HOW to Turn on the Power HOW to USE the Touch Screen HOW to SET UP the CONSOLE Connect to your wireless network Check for firmware updatesCalibrate the incline system Create an iFit Live account HOW to USE the Manual Mode When you are finished exercising, remove Plug the power cord. Important If you do notKey from the console Do this, the incline trainer’s electrical compo HOW to USE AN Onboard Workout Select an onboard workoutStart the workout HOW to USE a SET-A-GOAL Workout Select the main menu. See on Select a set-a-goal workout HOW to USE AN Ifit Live Workout Start the workout. See on HOW to USE the Equipment Settings Mode HOW to USE the Maintenance Mode Exit the maintenance modeCalibrate the incline system of the incline trainer Find Keycodes HOW to USE the Wireless Network Mode Enable Wi-FiSet up and manage a wireless network connection Exit the wireless network mode HOW to USE the Stereo Sound System HOW to USE the Internet Browser HOW to Move the Incline Trainer Troubleshooting Symptom The power turns off during use Symptom The walking belt slows when walked on Page Exercise Guidelines Exercise IntensityWorkout Guidelines Exercise Frequency Suggested Stretches Part List Qty Description Description Exploded Drawing a Exploded Drawing B 106 110 Exploded Drawing D Exploded Drawing E Ordering Replacement Parts Limited WarrantyIcon Health & Fitness, Inc., 1500 S W., Logan, UT