![](/images/new-backgrounds/1317279/31727917x1.webp)
4.Have a second person hold the console assem- bly near the Uprights (77). Insert the console wire and the “R” pulse wire from the console as- sembly through the indicated tie.
Connect the Upright Wire (78) to the wire ex- tending from the console assembly. See the inset drawing. The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF
YOU DO NOT CONNECT THE CONNECTORS PROPERLY, THE CONSOLE MAY BECOME DAMAGED WHEN YOU TURN ON THE POWER.
Remove the wire tie from the Upright Wire (78).
5.Insert the Upright Wire (78) into the right Upright (77) as you insert the Console Crossbar (101) into the Uprights. Be careful not to pinch the Upright Wire (78).
Loosen the four #8 x 1” Screws (102) (only two are shown) one turn.
Tighten two 5/16" x 2 1/2" Screws (4) with two 5/16" Star Washers (9) into the side of the right Upright (77) and into the Crossbar (103). Do not overtighten the Screws. Be careful not to pinch the Upright Wire (78).
Next, tighten two 5/16" x 5/8" Screws (11) into the right Upright (77) and the Console Crossbar (101). It may be necessary to slide the
Console Crossbar (102) to align the holes. Then, tighten the two #8 x 1" Screws (102).
Repeat this step on the other side of the in- cline trainer.
4
Tie
| R | “R” Pulse |
|
|
| L | |
|
| Wire | Console |
| Console | Assembly | |
78 |
| ||
Wire |
|
|
Wire Tie
77
Console
Wire
|
| 78 |
|
5 |
|
|
|
| 101 |
|
|
| 78 |
| 102 |
4 | 9 |
| |
|
| ||
|
| R |
|
|
| 103 | L |
|
|
| |
| 77 | 11 |
|
|
|
| |
9 |
|
|
|