808Zone Programming
The display shows the zone number and current attribute. |
|
Note that the zone number is flashing (shown here by an |
|
underline). |
To select a zone number:
3.Press the up or down arrow keys (A or B) until you see the zone number you want (in this example zone 3).
The display shows: |
4. Press Enter. |
|
The displays stops flashing the zone number and starts |
|
flashing the zone type: |
To select the zone type:
5.Press the up or down arrow keys (A or B) until the display shows the two letter code for the zone type you want (in this example NA for Normal Alarm).
The display shows: |
To allocate the zone to an area: |
|
6. Press the right arrow key (C). |
|
The display shows the current area number: |
7.Press one of the number keys 1 to 4 to select the area you want the zone to belong to (in this example Area 3).
The display shows the Area number you selected: |
To allocate zone attributes:
8.Press the right arrow key (C).
The display shows a letter code for the first of the available attributes belonging to the zone type you selected earlier. (In this example the zone type was NA and the first available attribute is C (Chime).) The
letter to the right of the attribute code shows whether |
|
the attribute is enabled (Y) or disabled (N). |
9.Press the up or down arrow keys (A or B) to enable or disable the attribute (in this example Chime is enabled.)
The display shows: |
10. Press the right arrow key to select the next available attribute.
The display shows the next attribute available for the |
|
selected zone type (in this example O (Omit)). |
11.Press the up or down arrow keys (A or B) to enable or disable the attribute.
496336 Issue 1 | 13 of 22 |