Seiko BX-900 owner manual Single sheet paper, Left Paper Guide

2. Setting up

❏Single sheet paper

1.Move the paper select lever toward the rear of the printer to the single sheet setting.

2. Set the print head adjustment lever . In general, position 1 is used 1

for one-part paper. See page 15.

3. Raise the paper rack to the vertical position and adjust the left 2

paper guide to the proper position for the size of the paper being used.

Note

If the paper is not loaded on the proper mark, the printer may not detect the paper and will display PAPER ERROR.

4.Place single sheet paper against the paper rack and let it slide behind the platen.

5.Adjust the right paper guide so that it comfortably holds the paper in between the two paper guides.

Paper Size Marker Extension Arm

4 Right Paper Guide

A3 B4

3Left Paper Guide

6.Press the FF key to load the single sheet paper to the top-of-form position 14/60 inch (6mm) below the top edge of the paper. The top-of-form position can be adjusted from 0/60 inch to 480/60 inches (8 inches = 203mm) by using the front panel controls in the basic setup options on page 31.

Note

If the paper is not completely fed in, slightly push the paper downward. If it is still not fed in, look in the TROUBLESHOOTING section.

7.The paper bail automatically lowers to press the paper against the platen when the leading edge of the paper feeds more than one inch onto the platen.

Notes

1.Extension Arm

The extension arm is used to keep large size (Legal, B4) single sheets from falling behind the paper rack. When using the extension arm, pull the arm until it clicks and locks in place.

2.TEAR OFF key is invalid with single sheet paper.

14