PROGRAMMING 1 hand control - 1 bed
The two step procedure below is required to program 1 hand control to operate 1 bed. Before beginning, make certain the bed is plugged into a working grounded electrical
outlet.
STEP 1
Locate the receiver unit (power down box) for the bed and press the learn button for 1 second and release (FIGURE 16).
Precision Comfort™ Owners Manual
18
POWER
DOWN BOX
LEARN
BUTTON
FIGURE 16: Power down box learn button.
STEP 2
On the hand control, simultaneously press and hold the POS 1 and head massage on/ off buttons (FIGURE 17). The transmission indicator light will flash slowly and then flash rapidly. Continue to hold for 5 seconds and then release the buttons.
One hand control is now programmed to operate one bed.
TRANSMISSION
INDICATOR LIGHT
POS 1
BUTTON
HEAD MASSAGE
ON/OFF BUTTON
FIGURE 17
IF PROGRAMMINGNOTEFAILS, INITIATE THE PROGRAMMING PROCEDURE A SECOND TIME.
