PROGRAMMING 2 hand controls - 1 bed
The three step procedure below is required to program 2 hand controls to operate 1 bed. Before beginning, make certain the bed is plugged into a working grounded electrical
outlet.
STEP 1
Locate the power down box for the bed and press the learn button for 1 second and release (FIGURE 16).
POWER
DOWN BOX
LEARN
BUTTON
FIGURE 16: Power down box learn button.
STEP 2
On hand control 1, simultaneously press and hold the POS 1 and the head massage on/off buttons (FIGURE 17). The transmission indicator light will flash slowly and then flash rapidly. Continue to hold for 5 seconds and then release the
buttons.
STEP 3
Repeat Step 1 and Step 2 with hand control 2.
Two hand controls are now programmed to operate one bed.
HAND | HAND |
CONTROL 1 | CONTROL 2 |
TRANSMISSION
INDICATOR LIGHT
POS 1
BUTTON
HEAD MASSAGE
ON/OFF BUTTON
FIGURE 17
IF PROGRAMMINGNOTEFAILS, INITIATE THE PROGRAMMING PROCEDURE A SECOND TIME.
Precision Comfort™ Owners Manual
19
