Using the devices
Using the devices
To establish a transmission link, proceed as follows:
1.Switch the transmitter on.
2.Switch the diversity receiver on. The transmission link is established.
It is vital to observe the notes on frequency selection on page 27.
If you cannot establish a transmission link between transmitter and receiver:
Make sure that transmitter and receiver are set to the same frequency bank and to the same channel – the easiest way is to synchronize the devices (see page 20).
If necessary, read the chapter “If a problem occurs ...” on page 29.
Switching the devices on/off
Switching the SR 300 IEM G3 transmitter on/off
To switch the transmitter on (online operation):
| Press the STANDBY button . |
| The transmitter switches on and the standard display appears. |
| The transmitter transmits an RF signal and the transmission icon is displayed. |
To switch the transmitter on and to deactivate the RF signal on
Press the jog dial.
The transmission frequency is displayed but the transmitter does not transmit an RF signal. The transmission icon is not displayed. In addition, the display backlighting changes from orange to red and “RF Mute” flashes in alternation with the standard display.
Use this function to prepare a transmitter for use during live operation without causing interference to existing transmission links.
To activate the RF signal:
Briefly press the STANDBY button .
“RF Mute Off” appears on the display panel.
Press the jog dial.
The transmission icon is displayed again.
To switch the transmitter to standby mode:
If necessary, deactivate the lock mode (see page 18).
Keep the STANDBY button pressed until “OFF” appears on the display panel. The transmitter switches to standby mode.
16