Sennheiser EK 300 IEM G3, 300 IEM Series Synchronizing the transmitter with the diversity receiver

Synchronizing the transmitter with the diversity receiver

When synchronizing the transmitter with the receiver, please observe the following:

Only use a transmitter and a receiver from the same frequency range (see the type plate on the transmitter and the receiver).

Make sure that the desired frequencies are listed in the enclosed frequency information sheet. You can also contact your Sennheiser partner who will be pleased to calculate intermodulation-free frequencies for you.

Make sure that the desired frequencies are approved and legal in your country and, if necessary, apply for an operating license.

The frequency information sheet can also be downloaded from the corresponding product page on our website at www.sennheiser.com.

Synchronizing the transmitter with the receiver – individual operation

Upon delivery, transmitter and receiver are synchronized with each other. If, however, you cannot establish a transmission link between transmitter and receiver, you have to synchronize the channels of the devices:

First carry out the Easy Setup Sync function (see table on page 21, left-hand column). The transmitter is set to a suitable frequency.

Then carry out the Sync function (see table on page 21, right-hand column). This establishes a transmission link between transmitter and receiver.

Alternatively, you can set the channel on the transmitter manually:

Make sure that you set the transmitter to the same frequency bank and the same channel as the receiver.

	Synchronizing transmitters with receivers – multi-channel operation
Network operation	In multi-channel operation, the transmitters are remote controlled via a PC running the
using the WSM	“Wireless Systems Manager” (WSM) software.
	Advantages of controlling the transmitters via the “Wireless Systems Manager”
	(WSM) software:
	• Detailed overview of all transmission and receiving channels
	• Remote control of all transmitters in the network
	• Combination of transmitters of different frequency ranges (see page 4)
	Connect your transmitters and your PC in a network (see page 13).
	Switch your transmitters and your PC on (see page 16).
	Launch the “Wireless Systems Manager” (WSM) software.
	To set up your multi-channel system, proceed as described in the instruction manual of
	the “Wireless Systems Manager” (WSM) software.
Operation without	First carry out the Easy Setup Sync function (see table on page 21, left-hand column).
network	All transmitters are set to suitable transmission frequencies.
	Then carry out the Sync function for each transmitter/receiver pair (see table on page 21,
	right-hand column).
	This establishes a transmission link between each transmitter/receiver pair.