Using the receiver

Using the receiver

To establish a transmission link, proceed as follows:

1.Switch the receiver on (see next section).

2.Switch the transmitter on (see the instruction manual of the trans- mitter).

The transmission link is established and the display backlighting of the receiver changes from red to orange.

It is vital to observe the notes on frequency selection on page 44.

If you cannot establish a transmission link between transmitter and receiver:

￿Make sure that transmitter and receiver are set to the same frequency bank and to the same channel.

￿Read the chapter “Synchronizing transmitters with receivers” on page 44 and, if necessary, the chapter “If a problem occurs ...” on page 50.

Switching the receiver on/off

40

PEAK0

B.Ch: 20.24 ew300 G3

30

-10

531.375MHz

20-20

10

-30

EQ

SKM300

 

-40

P + 12dB

 

RF

AF

 



To switch the receiver on:

￿Briefly press the STANDBY button .

The receiver switches on and the “Receiver Parameters” stan- dard display appears.

20