Using the receiver

Synchronizing a transmitter with the receiver

You can synchronize a suitable transmitter of the ew 300 G3 series with the receiver. If the receiver is in ex works condition, the following parameters are transferred to the transmitter during synchronization:

Setting

Transferred parameters

 

 

“Frequency Preset” Currently set frequency

“Name”Freely selectable name currently set on the receiver

“Pilot Tone” Current pilot tone setting of the receiver (“Inactive”/“Active”)

Via the “Sync Settings” submenu, you can adjust the parameters to be transferred to your transmitters (see page 39). It is vital to observe the notes on frequency selection on page 44.

To transfer the parameters:

￿Switch the transmitter and the receiver on.

￿ 

￿ 

￿Press the button  on the receiver.

“Sync” appears on the display panel of the receiver.

￿Place the infra-red interface of the transmitter (see the instruction manual of the transmitter) in front of the infra-red interface  of the receiver.

The parameters are transferred to the transmitter. When the transfer is completed, “” appears on the receiver’s display panel. The receiver then switches back to the current standard display.

22