Sennheiser EM 3732 Putting the receiver into operation, Fitting the device feet, Rack mounting

Putting the receiver into operation

Putting the receiver into operation

Fitting the device feet

When the receiver is not installed in a rack, avoid the receiver sliding around and reduce the chance of damage to the receiver and to any surface on which it is placed by fixing the four soft rubber self adhesive feet to the base of the receiver in the positions indicated.

Note:

Do not fit the rubber feet when rack mounting the receiver.

CAUTION! Risk of staining of furniture surfaces!

Some furniture surfaces have been treated with varnish, polish or synthetics which might cause stains when they come into contact with other synthetics. Despite a thorough testing of the synthetics used by us, we cannot rule out the possibility of staining.

￿Do not place the receiver on delicate surfaces.

￿Ensure that the base of the receiver is clean and free from grease before fitting the rubber feet.

￿Fix the rubber feet to the base of the receiver by peeling off the backing paper and fitting them as shown in the diagram on the left.

Rack mounting

CAUTION! Risks when rack mounting the receiver!

When installing the device in a closed or multi-rack assembly, please consider that, during operation, the ambient temperature within the rack may significantly rise above room temperature.

￿The ambient temperature within the rack must not exceed the temperature limit specified in the specifications.

￿When installing the device in a rack, take good care not to affect the ventilation required for safe operation or provide additional ventilation.

￿Make sure the mechanical loading of the rack is even to avoid a hazardous condition such as a severely unbalanced rack.

￿When connecting the device to the power supply, observe the information indicated on the type plate. Avoid circuit overloading. If necessary, provide overcurrent protection.

￿Ensure a reliable mains ground connection of the device by taking appropriate measures.

￿When installing the device in a closed or multi-rack assembly, please note that intrinsically harmless leakage currents of the individual devices may accumulate, thereby exceeding the allowable limit value. As a remedy, ground the rack via an additional ground connection.

13