Sennheiser EM 3732 Connecting the headphones/adjusting the volume, Deactivating the lock mode

Using the receiver

True Diversity Receiver EM 3732

Connecting the headphones/adjusting the volume

CAUTION! Danger of hearing damage!

Listening at high volume levels for long periods can lead to permanent hearing defects.

￿Set the volume for the connected headphones to the minimum before putting the headphones on.

The EM 3731 single receiver features a headphone output 2. The two receivers of the EM 3732 or EM 3732 Command twin receiver have a common headphone output 2. This common headphone output 2allows you to either monitor the audio signal of one receiver or to simultaneously monitor the audio signals of both receivers.

￿Set the headphone volume control 3 to the lowest volume by turning

300			PEAK	790.80	it to the left as far as possible.
100		100
A RF		B % DEV
10				03.03C
30		50		B	￿ Connect headphones with a ¼” (6.3 mm) stereo jack plug to the
	μV		10

headphone output 2.

To monitor the audio signals of one of the two receivers of a twin receiver:

100		100	790.800 z
	A RF B	% DEV	M
300		PEAK	H
10			03.03CH
30		50	BANK
	μV	10

AF COM

esc

save

sync

￿Press the headphone button 0of the receiver whose audio signals you want to monitor.

Hold esc to unlock

To simultaneously monitor the audio signals of both receivers of a twin receiver:

￿Simultaneously press the headphone buttons 0 of both receivers. The audio signals of the left receiver are output via the left headphone channel, the audio signals of the right receiver are output via the right headphone channel.

￿Increase the volume gradually.

To switch the headphone output off:

￿Press the headphone button 0 of the receiver whose headphone output you want to switch off.

Deactivating the lock mode

When the receivers are remote controlled via a PC and the supplied “Wireless Systems Manager” software, their buttons can be locked via the “Wireless Systems Manager” software.

To deactivate the lock mode:

￿Press the esc button 6 until the progress bar is complete and the status display appears.

The lock mode is deactivated and the settings can be made manually.

20