Sennheiser EM 3732 AF out Not pressed Command Off Pressed, Not pressed AF out Command Off Pressed

The operating menu

Command

		1
		AF
		AF COM
DEV	M	save digital audio
	790.800 z	processing
	H
	03.03CH	sync
	BANK AF COM	esc

sync

Note:

If you select “Ext.” even though no external word clock signal is available at the BNC socket for word clock input H (e.g. because the external word clock generator is not connected or switched off), the display for external word clock synchronization B starts flashing and the last set sampling rate remains active.

Configuring the audio outputs of the EM 3732 Command twin receiver

The EM 3732 Command twin receiver has two audio outputs per receiver:

1.the audio outputs AF out 1 M and AF out 2 K,

2.the command outputs Command 1 L and Command 2 J.

These audio outputs can be switched on and off via a button on the transmitter – provided that the transmitter is also equipped with the command function (a separate power pack with command button is available for the SKM 5200 transmitter).

Via the “Command” menu, you can determine which of the audio and command outputs are switched on and off when the command button on the transmitter is pressed. There are four configuration options:

If the “Command”			… AND the	… THEN the
menu of the receiver is			command button	receiver’s audio
configured as shown			on the transmitter	outputs are
below …			is …	switched ...
				AF out:	on
		1	not pressed			AF
				Command:	off
	AF		pressed	AF out:	on	AF
	AF	COM
				Command:	off	COM
		2	not pressed	AF out:	on	AF
				Command:	off
	AF		pressed	AF out:	off
		COM
				Command:	on	COM
				AF out:	on
		3	not pressed			AF
				Command:	on	COM
	AF	COM	pressed	AF out:	off
		COM		Command:	on	COM
		4	not pressed	AF out:	on	AF
				Command:	on	COM
	AF	COM	pressed	AF out:	on	AF
	AF	COM
				Command:	on	COM

The active output lights up in the command display; muted outputs are not displayed (see “Command display (status display of the audio outputs AF and COM)” on page 11).

￿Change to the setting mode of the “Command” menu. The current configuration starts flashing.

￿Select one of the four configurations by turning the jog dial 7.

Note:

If you do not want to use the command function, select the configuration “4”.

32