Sennheiser EM 3732 manual Synchronizing the transmitter with the receiver frequency, Red

EV 790.800 M

H

z

03.03BANK

CH

AF COM

save digital audio processing

sync

esc

sync

Using the receiver

Synchronizing the transmitter with the receiver frequency

Via its infra-red interface, the receiver can transfer the frequency and the name to suitable transmitters (e.g. SK 5212, SKM 5200 or SKP 3000).

Note:

The transmitter must be from the same frequency range (“A” to “I”, see page 5) and be equipped with the same compander system (HDP, see page 38) as the receiver!

￿Set the receiver to the desired receiving frequency (see “Setting the receiving frequency” on page 28 and “Selecting a frequency bank and a channel” on page 28) and enter the desired name (see “Entering a name” on page 29).

￿Press the sync button 9.

The two blue LEDs in the infra-red interface (sync) A flash and the backlighting of the sync button 9flashes red. The receiver is ready for synchronization.

￿Position the transmitter’s infra-red interface at a max. distance of 5 cm in front of the infra-red interface (sync) A.

The transfer starts automatically. During the transfer, the two blue

save digital audio	A RF B		%	LEDs in the infra-red interface (sync) A flash and the backlighting of
				the sync button 9 flashes green.
processing
	300		PEA
sync	100		10
	30
esc			5	– After successful completion of the synchronization, the two blue
		V
sync
	10
	μ		1
				LEDs in the infra-red interface (sync) A stop flashing and
				the sync button 9 is backlit in green. The receiver’s frequency and
				name are now also set on the transmitter and the transmission link
				is ready for operation.

<5cm

–If an error occurred during synchronization (e.g. the transmitter is

too far away from the receiver), the two blue LEDs in the infra-red interface (sync) A stop flashing and the sync button 9 is backlit in

red.

Note on the SKM 5200 hand-held transmitter:

SKM 5200

The infra-red interface of the SKM 5200 hand-held transmitter is located at the left-hand margin of the display. Position the transmitter’s infra-red interface precisely in front of the infra-red interface (sync) A of the receiver.

21