The operating menu

MAC

00 1B

66 00

00:1B:66:00:00:01 00 01

Standby

 

 

OFF

DEV

M

save digital audio

 

790.800 z

processing

 

H

 

03.03CH

sync

 

esc

 

BANK AF COM

sync

Reset

Reset to

factory defaults ? 000

DEV

M

save digital audio

 

790.800 z

processing

 

H

 

03.03CH

sync

 

esc

 

BANK AF COM

sync

To automatically obtain an IP address (dynamic IP addressing):

￿Change to the setting mode of the IP-Addr menu. The first byte starts flashing.

￿Press the jog dial 7 several times until the arrow points to “Auto”.

￿Press the save button 8.

￿Switch the receiver off and on again (see “Switching the receiver on/ off” on page 19).

The new IP address becomes effective.

Displaying the network address (MAC address)

Via the “MAC” menu, you can display the Media Access Control (MAC) address of the Ethernet interface. The MAC address is fixedly stored in each receiver and cannot be changed.

￿Change to the setting mode of the “MAC” menu. The 12-digit MAC address is displayed.

Setting a receiver to standby mode

You can set a receiver to standby mode and mute it. To do so, proceed as follows:

￿Change to the setting mode of the “Standby” menu.

The icon and the green backlighting of the save button 8 flash.

￿Press the save button 8.

The esc button 6 is backlit in red. The receiver is set to standby mode and the display is switched off.

Note:

The standby mode remains active even when you switch the receiver off and on again.

To end the standby mode:

￿Press the jog dial 7 or the esc button 6. The display is switched on.

Loading the factory-preset default settings

Via the “Reset” menu, you can reset the current settings to the factory- preset default settings.

￿Change to the setting mode of the “Reset” menu.

The question “Reset to factory defaults?” appears. The green backlighting of the save button 8 flashes.

￿Press the save button 8 until the progress bar is complete.

The factory-preset default settings are loaded. The display changes to the selection mode of the operating menu.

37

Page 85
Image 85
Sennheiser EM 3732 manual Displaying the network address MAC address, Setting a receiver to standby mode