Using the transmitter

Using the transmitter

To establish a transmission link, proceed as follows:

1.Switch the transmitter on (see below).

2.Switch the EK 2000 IEM receiver on (see the instruction manual of the receiver). The transmission link is established.

It is vital to observe the notes on frequency selection on page 22.

If you cannot establish a transmission link between transmitter and receiver:

￿Make sure that transmitter and receiver are set to the same frequency bank and to the same channel.

￿If necessary, read the chapter “If a problem occurs ...” on page 24.

Switching the transmitter on/off

To switch the transmitter on (online operation):

0**

 

￿ Briefly press the STANDBY button .

 

 

 

 

The transmitter switches on and the standard display appears.

 



The transmitter transmits an RF signal and the transmission icon ! is displayed.

 

 

To switch the transmitter to standby mode:

￿If necessary, deactivate the lock mode (see page 14)

￿Keep the STANDBY button  pressed until “OFF” appears on the display panel. The display panel switches off.

When in the operating menu, pressing the STANDBY button will cancel your entry (ESC function) and return you to the standard display.

The STANDBY button is backlit in red both during operation and in standby mode.

To switch the transmitter on and to deactivate the RF signal on switch-on(offline operation): ￿ Press the STANDBY button  until “RF Mute On?” appears on the display panel.

￿ Press the jog dial.

The transmission frequency is displayed but the transmitter does not transmit an RF signal. The transmission icon !is not displayed.

PEAK PEAK

00 -10 -10-20-20

B.Ch: 5.14

**2000**

552.300MHz !

-30 -40 AF I

-30 -40 AF II

EQ Standard -18dB

To completely switch the transmitter off:

￿Disconnect the transmitter from the mains by unplugging the mains plug from the wall socket.

The backlighting of the STANDBY button  goes off.

13