Sennheiser SR 2000 IEM, SR 2050 IEM Monitoring the audio signal via headphones, Synchronizing transmitters and EK 2000 IEM receivers via the infra-redinterface

Using the transmitter

During mono operation, you have to deactivate the pilot tone evaluation on the EK 2000 IEM receiver in order to ensure that your receiver outputs the same signal on channel I and II.

CAUTION!

Stereo Transmitter SR 2000 IEM

PEAK PEAK

00 -10 -10 -20 -20 -30 -30

-40 -40

AF I AF II

Monitoring the audio signal via headphones

You can monitor the audio signal via the headphone output .

Danger of hearing damage!

Listening at high volume levels for long periods can lead to permanent hearing defects.

Set the headphone volume control to the minimum position before putting the head- phones on.

Set the headphone volume control to the minimum position.

Connect headphones with a ¼” (6.3 mm) stereo jack plug to the headphone output .

Gradually increase the volume and monitor the audio signal with the lowest possible volume.

Synchronizing transmitters and EK 2000 IEM receivers via the infra-red interface

Synchronization allows you to quickly and easily transfer transmitter and receiver settings from one device to the other, especially if you want to configure a multi-channel system. There are two transfer directions:

1.Easy Setup Sync: Transfer from the receiver to one or several transmitters

Once you have performed a frequency preset scan with your receiver, you can use the Easy Setup Sync function to transfer unused frequency presets from the receiver to the transmitters via the infra-red interface. In order to configure a multi-channel system, you use the diversity receiver to transfer the first unused channel from the selected frequency bank to the first transmitter and the next unused channel to the second transmitter and so on, thus ensuring that all transmitters of a multi-channel system operate on suitable frequencies.

2.Sync: Transfer from a transmitter to a receiver

Once you have selected and set the desired receiver settings on the transmitter (either manually or using the Easy Setup Sync function), you transfer these settings to a receiver. This configures the receiver and establishes a transmission link between transmitter and receiver.

Via the “Sync Settings” submenu, you can adjust the receiver parameters listed below and activate or deactivate their transfer to an EK 2000 IEM receiver.

Setting	Transferred receiver parameter
“Balance”	Current balance setting (“−15”/“+15”)
“Squelch”	Current squelch setting (“Off”, “5 dB” ... “25 dB”)
“Mode”	Current audio mode setting (“Stereo”/“Focus”)
“High Boost”	Current treble boost setting (“flat”/“High boost”)
“Auto Lock”	Current lock mode setting (“active”/“inactive”)
“Limiter”	Current limiter setting (“−18 dB”, “−12 dB”, “−6 dB”, “Off”)