Cleaning the transmitter
Using freely selectable transmission frequencies
You can also freely select the frequencies and store these frequencies in the frequency banks “U1” to “U6”.
If you want to use the frequency banks “U1” to “U6”:
Make sure to use transmitters and receivers from the same frequency range (see page 4 and the type plates of the devices).
To ensure that the desired frequencies are
Contact your Sennheiser partner (see www.sennheiser.com).
Set each transmitter to the same frequency bank.
On one of the transmitters, select a channel within this frequency bank (see page 19).
Assign this channel one of the calculated transmission frequencies (see page 19).
Synchronize a receiver with your transmitter (
, see page 16)
OR
Manually set the receiver to the same frequency bank, channel and frequency that you set on the transmitter.
Repeat for the remaining transmitters and receivers as described above.
| Cleaning the transmitter |
|
|
CAUTION! | Liquids can damage the electronics of the transmitter! |
| Liquids entering the housing of the device can cause a |
| electronics. |
| Keep all liquids away from the transmitter. |
Before cleaning, disconnect the device from the mains.
Use a slightly damp cloth to clean the device from time to time. Do not use any solvents or cleansing agents.
| Accessories |
Cat. No. | Accessory |
004368 | GA 3030 AM antenna front mount kit |
502048 | AC 3200 antenna combiner |
500887 | A 5000 CP circularly polarized broadband antenna |
003658 | A 2003 directional broadband antenna |
004645 | A 1031 |
087969 | Antenna |
002324 | GZL |
23