Synchronizing the transmitter with an EK 2000 IEM receiver
Synchronizing the transmitter with an EK 2000 IEM receiver
When synchronizing your transmitter with an EK 2000 IEM receiver, please observe the following:
Only use a transmitter and a receiver from the same frequency range (see the type plate on the transmitter and the receiver).
Make sure that the desired frequencies are listed in the enclosed frequency infor- mation sheet.
Make sure that the desired frequencies are approved and legal in your country and, if necessary, apply for an operating license.
Synchronizing the transmitter with an EK 2000 IEM receiver – individual operation
Upon delivery, transmitter and receiver are synchronized with each other. If, however, you cannot establish a transmission link between transmitter and receiver, you have to synchronize the channels of the devices:
Carry out the Easy Setup Sync function and then the Sync function (see page 16).
Alternatively, you can set the channel on the transmitter manually:
Make sure that you set the transmitter to the same frequency bank and the same channel as the receiver.
Synchronizing transmitters with EK 2000 IEM receivers –
Network operation In
Advantages of controlling the transmitters via the “Wireless Systems Manager” (WSM) software:
•Detailed overview of all transmission and receiving channels
•Remote control of all transmitters in the network
•Combination of transmitters of different frequency ranges (see page 4).
Connect your transmitters and your PC in a network (see page 12).
Switch your transmitters and your PC on.
Launch the “Wireless Systems Manager” (WSM) software.
To set up your
Operation without Carry out the Easy Setup Sync function and then, for each transmission link, the Sync
network function (see page 16).
22