Command Line Interface
Logging In
Logging in through Telnet requires directing the Telnet client to the configured IP address of the unit.
Logging in through the Console (RS232) port requires the use of a terminal or terminal emulation software configured to support ANSI or VT100 and a supported data rate (300, 1200, 2400, 4800, 9600, 19200, 38400, 57600, or 115200 BPS) - 8 data
To log in by
1.Press Enter. The following appears, where x.xx is the firmware version:
Sentry Version x.xx
Username:
NOTE: Logging in by Telnet will automatically open a session. It is not necessary to press Enter.
2.At the Username: and Password: prompts, enter a valid username and password. And press Enter.
You are given three attempts to enter a valid username and password combination. If all three fail, the session ends.
NOTE: The default Sentry username/password is admn/admn.
When you enter a valid username and password, the command prompt (Sentry:) appears. If a location identifier was defined, it will be displayed before the Sentry: prompt. See Creating a location description on page 37 for more information.
Commands may be entered in any combination of uppercase and lowercase. All command characters must be entered correctly; there are no command abbreviations. A user must have administrative privileges to use the administration commands. The following tables list and briefly describe each command.
Operations Command Summary
Command | Description |
|
|
On | Turns one or more outlets on |
|
|
Off | Turns one or more outlets off |
|
|
Reboot | Reboots one or more outlets |
|
|
Status | Displays the on/off status of one or more outlets |
|
|
ILoad | Displays the total cumulative input load |
|
|
Istat | Displays the status of the infeeds |
|
|
Connect | Connects to a serial port |
|
|
Envmon | Displays the status of the integrated Environmental Monitor |
|
|
Login | Ends the current session and brings up the Username: prompt |
|
|
Logout | Ends a session |
|
|
Quit | Ends a session |
|
|
List Outlets | Lists all accessible outlets for the current user |
|
|
List Ports | Lists all accessible serial ports for the current user |
|
|
List Group | Lists all assigned outlets for a group name |
|
|
List Groups | Lists all accessible groups for the current user |
Administrative Command Summary
Add Grouptouser | Grants a user access to one or more groups |
|
|
|
|
Add Outlettogroup | Adds an outlet to a group name |
|
|
|
|
Add Outlettouser | Grants a user access to one or all outlets |
|
|
|
|
Add Porttouser | Grants a user access to one or all serial ports |
|
|
|
|
Create Group | Adds a group name |
|
|
|
|
Create User | Adds a user account |
|
|
|
|
Delete Groupfromuser | Removes access to one or more groups for a user |
|
|
|
|
Delete Outletfromgroup | Deletes an outlet from a group name |
|
|
|
|
Delete Outletfromuser | Removes access to one or all outlets for a user |
|
|
|
|
22 • Operations | Sentry PT22 |
| Installation and Operations Manual |