Sentry 2.0
Digital Temperature Controller
Complete Operating Instructions
See pages
100, 600, 800 or 1000 series board to the Sentry.
Cone-Fire (pg 8-11)
From IdLE, press 1.
Available only on ceramic kilns. Fires to a pyrometric cone. Enter cone, speed,
Ramp-Hold (pg 12-15)
From IdLE, press 4.
Select stored program (1 - 4). Enter rate, temperature, and hold for each segment.
Alarm (pg 6)
From IdLE or during firing, press 7.
Enter a temperature. When alarm sounds during firing, press Enter.
Enter/Start (pg 7)
Press Enter/Start after each step in programming a firing. Press Enter/Start once to be- gin the firing.
Delay (pg 6)
From IdLE, press 3.
Enter time in hours:minutes. Delays the start of firing.
Add Time (pg 6)
During firing, press 2.
Each additional key press adds five minutes to a hold. It works in both
Present Status (pg 6)
Press 5 during firing.
Shows the segment that is currently firing. Works in both
Program Review (pg 6)
From IdLE or during firing, press 6.
Shows the program that is loaded in memory and ready to fire, or the one that is firing.
Options (pg 17 - 21)
From IdLE, press 0. Press Enter for option displayed.
SPd Speed Change the speed of a
OFST Cone Offset Adjust con- troller to a witness cone.
FAN Vent Fan Selects when the vent fan will operate. (Special
Id Computer ID Select identi- fication number for output to a computer.
TEdE Temperature Deviation Set temperature sensitivity of er- ror codes.
SFTY Maximum temp.
ELEC Electronics Temp. Check board for overheating.
LOCK Program Lock Make a
Stop/Back (pg 7)
Press during firing or programming.
Stops a firing. In Options, takes you back to IdLE. During programming, takes you back one step each time key is pressed.
Cone Table & Skip Segment (pg 7)
From IdLE or during firing, press 9.
From IdLE, shows tempera- ture for the cone you enter. While Firing: In
option not on all kilns.)
Standard Options
TCOS Thermocouple Offset Calibrate the thermocouple temperature.
CHG- Select °F or °C.
TC Thermocouple Type Se- lect Type K, S or R.
AOP AOP Outlet Select vent fan or alarm. This is a special op- tion not on all kilns.
program
CFG Configuration Code For technicians.
SOFT Software Version For technicians.
TEST Element Test Diagnos- tics tool for checking elements.
RST Reset Removes cone and thermocouple offsets, etc.
Multiple Zone Options
DIFF Difference Largest temperature difference be- tween any two zones.
CAdJ Center Adjustment Change center heat of some
T123 Zone Tempera- tures Shows temperature of each zone.
1