Servis-Rhino FM84A manual Maintenance, BLADE SPINDLE INSTRUCTIONS - Figure, Assembly Procedure

MAINTENANCE

MAINTENANCE

BLADE SPINDLE INSTRUCTIONS - Figure 9

ASSEMBLY PROCEDURE

1.Press (Item 6) Cup into both ends of (Item 3) Housing Spindle.

2.Install (Item 5) Bearing into (Item 6) Cup on bottom side of (Item 3) Housing Spindle.

3.Press (Item7) Seal into bottom of (Item3) Housing Spindle. (NOTE:POSITION & DIRECTION OF SEAL FLUSH WITH HOUSING)

4. After Completing Steps 1-3

Press Housing/Bearing Assy. Onto Shaft Aassy. DO NOT USE HYDRAULIC PRESS

5.Drive (Item 5) Top Bearing onto (Items 1&2) assy. shaft seal protector.

6.Press (Item 7) seal into top of (Item 3) housing spindle. (Note position & direction of seal)

7.Install (Item 4) nut adjusting (Adjust nut to give bearing end play of .002"-.006" apply loctite 242 to nut.)

8.Install (Item 9) set screw

9.Install (Item 10) grease fitting.

Disassembly Procedure

1.Loosen set screw (9) in adjusting nut (4).

2.Remove adjusting nut (4)

3.Support housing (3) flange and press or drive shaft assembly (1) from housing, taking care to prevent damage to the grease fitting (10) and shaft (1) threads.

4.Remove bearing cups (6) from housing.

5.Reinstall adjusting nut (4) on shaft and support shaft assembly (1) upside down against adjusting nut

6.Remove lower bearing cone (5) from shaft assembly by inserting a 3/16" diameter drift punch through holes in seal protector (2) and driving bearing down until loose on the shaft (1).

7.Remove adjusting nut(4) and continue driving bearing off the rest of the shaft (1).

FIGURE 9

FM84A 09/03	Maintenance Section 5-8
© 2004 Alamo Group Inc.