Sharp Multi-bypass tray AL-1553, AL-1555, Open the multi-bypass tray and extend the tray

BYPASS FEED (including special paper)

The multi-bypass tray (AL-1553, AL-1555) or the single bypass (AL-1552) can be used to feed standard paper, transparency film, labels, envelopes, and other special purpose paper. Paper measuring from A6 to A4 and in the weight range of 52g/m2 to 128g/m2 can be used in this tray. (For paper weighing from 104g/m2 to 128g/m2, A4 is the maximum size.)

•The multi-bypass tray (AL-1553, AL-1555) can hold maximum of 50

sheets of paper. (Capacity will vary depending on the type of paper loaded.) The single bypass (AL-1552) can hold one sheet of paper.

•The original image must be smaller than the paper or media for copying. If the original image is bigger than the paper or media, this may cause smudges on the edges of the copies.

The multi-bypass tray (AL-1553, AL-1555)	3
1 Open the multi-bypass tray and extend the tray.

To close the multi- bypass tray, perform step 1 and then step 2 in the illustration and push the round projections at the right of the tray until they click.

2 Set the paper guides to the paper width. Insert the paper (print face down) all the way into the multi-bypass tray.

Print face

•Paper must be fed narrow side into the feed slot.

• Special papers such as transparency film ,labels and envelopes must be fed one sheet at a time through the multi-bypass tray.

•When copying onto transparency film, remove each copy promptly. Do not let copies stack up.

3 Press the tray select () key to select the multi-bypass tray.

17