Sharp AL-2050CS MAKING COPIES, the originals, force them in, Using the RSPF, press the [START] key, Check RSPF open function, Place the original(s) face up in the

MAKING COPIESCheck RSPF open function

When enabled in program number 24 (p.65), this function may help prevent wasteful use of toner that occurs when the RSPF cover is not completely closed.

If the start ( ) key is pressed when the RSPF cover is not completely closed, "CHECK ORIGINAL" will appear in the display and copying may not take place. If copying does not take place, copying can be performed by pressing the start ( ) key again, however, the scan size set in "CHANGING A TRAY'S PAPER SIZE SETTING" (p.23) or "VALID COPY WIDTH" (program number 25) (p.65) will be used.

If the RSPF cover is completely closed after "CHECK ORIGINAL" appears, copying will take place at the normal size.

Note	When this function is off, if the [Start] key (	) is pressed to make a copy
	with the RSPF cover open, parts outside of the original will be copied black.
	Even when this function is on, if the [Start] key (		) is pressed twice to
	make a copy with the RSPF cover open, parts outside the original may be
	copied black. To prevent excessive use of toner, make sure that the RSPF
	cover is closed when making a copy.

Using the RSPF	3

• Originals that are 5-1/2" x 8-1/2" to 8-1/2" x 14" and 15 lbs. to 24 lbs. (56 g/

Note m2 to 90 g/m2) can be used. A maximum of 50 pages can be placed at once.

•Straighten curled originals before placing them in the document feeder tray. Curled originals may cause misfeeds.

•Place originals horizontally.

•Before placing originals in the document feeder tray, be sure to remove any staples or paper clips from them.

•When a copy is made, the edges will not be copied (image loss). For the image loss, see the "SPECIFICATIONS" (p.91).

•When using the margin shift function, check the position of the margins carefully. (p.38)

1Make sure that an original has not been left on the document glass.2Adjust the original guides to the size ofthe originals.

3	Place the original(s) face up in the		Original face up
	document feeder tray without trying to		Original face up
	force them in.
	The RSPF indicator on the operation panel will light
	up. If this indicator does not light up, the originals are
	not properly set or the RSPF is not properly closed.
4	Select the number of copies and any other copy settings, and then
	press the [START] key (	).

• The default output mode for copying from the RSPF is sort mode (P.33),

Note and a checkmark " " will automatically appear in the display (P.11). If "SORT AUTO SELECT" is disabled in the user programs, the default output mode will be non-sort mode. (P.65)

•To stop copying in the middle of a run, press the [CLEAR] key ( ).

•For the copy settings, see pages 27 through 39.