Sharp AL-2050CS TROUBLESHOOTING AND MAINTENANCE

TROUBLESHOOTING AND MAINTENANCE

	Indication		Cause and remedy		Page
Lamp indicator		Display
		INSTALL A TD	The TD (Toner/Developer) cartridge is
			not installed correctly. Reinstall the TD		82
		CARTRIDGE.
			cartridge.
	Blinks
		REPLACE THE	The drum cartridge has reached the
Error		DRUM	end of its life. Replace it with a new		84
		CARTRIDGE.	drum cartridge.
indicator
		TD CARTRIDGE	Toner is low. Purchase a new TD		82
		IS NEAR EMPTY.	(Toner/Developer) cartridge.
	Steadily
		A DRUM	Less than 1000 sheets can be printed
	lit	CARTRIDGE WILL	with the current drum cartridge.		84
		BE NEEDED SOON.	Purchase a new drum cartridge.
MEMORY	FULL, PRESS START TO		Data is being held in memory. Print the		34
RESUME.			data or clear it from memory.
NO 2-SIDED COPY FROM BYPASS			Two sided printing or 2 IN 1 copying is
TRAY.			selected when the bypass tray is
			already selected ,or the bypass tray is
			selected when two-sided printing or 2		30
NO 2IN1 COPY FROM			IN 1 copying is already selected.		35
BYPASS TRAY.			The bypass tray cannot be used. Press
			the [TRAY SELECT] key (	) to select
			a paper tray.
			2 IN 1 copy and margin shift cannot be		35
NO 2IN1 COPY WITH MARGIN SHIFT.			used in combination. Cancel the
					38
			function that was selected last.
COPY RATIO CAN NOT BE			Copy ratio can not be changed in 2 IN		29
CHANGED IN 2IN1.			1 copy.		35
THIS MENU IS NOT SELECTABLE			This appears if you attempt to change
			a user program setting while a print job		62
WITH DATA.
			is in progress.
			There is no paper for printing. Press
			the [MODE SELECT] key to switch to
NO XXXX SIZE TRAY			printer mode and follow the instructions		-
			in the display.
			("XXXX" indicates paper size)
			An original remains on the document
			glass, or the original is too thick to		25
			scan. Remove the original.
CHECK SPF/RSPF.
			If the message is not cleared when there
START TO RESUME.			is no original on the document glass, the
			underside of the RSPF is dirty. Clean the		87
			underside of the RSPF. (especially areas
			where black lines appear.)
			Printing is not possible if the paper size
			setting is different from the size of
			paper loaded in the tray. Load the
LOAD XXXX PAPER INTO TRAY<*>.			same size of paper as the paper size		19
			setting and then press the [START] key
			( ). Printing will begin.
			("XXXX" indicates paper size. The tray
			is indicated in <*>.)
NO PC COMMUNICATION; CHECK			The machine is not correctly connected
			to the computer. Check the cable		46
CABLE.
			(when using the scanner function).

70