|
|
|
|
| CONNECTING TO A COMPUTER | |
|
|
|
|
| ||
CONNECTING A PARALLEL CABLE | ||||||
|
|
|
|
|
|
|
| 1 | Ensure that your computer and the | 3 | Plug the other end of the cable into | ||
|
| machine are turned off. |
|
| your computer's parallel port. | |
2 Plug the cable into the parallel port on the machine, and fasten with the clasps.
CONFIGURING THE PRINTER DRIVER
After installing the MFP driver (printer driver), you must configure the printer driver settings appropriately for the number of paper trays on the machine and the size of paper loaded in each.
1 Click the "start" button, click "Control Panel", click "Printers and Other Hardware", and then click "Printers and Faxes".
In operating systems other than Windows XP, click the "Start" button, select "Settings", and then click "Printers".
5 Click the "Set Tray Status" button and select the size of paper that is loaded in each tray.
Select a tray in the "Paper source" menu, and select the size of paper loaded in that tray from the "Setting Paper Size" menu. Repeat for each tray.
2 Click the "SHARP
If you are using Windows NT 4.0/2000/XP, go to step 4.
3 In Windows 95/98/Me, click the "Setup" tab.
4 Click the "Configuration" tab and set the printer configuration based on the options that have been installed.
Set the printer configuration properly. If not, |
| |
printing may not take place correctly. | If the dual function board is not installed, be sure | |
Caution | ||
to configure the above "Set Tray Status" | ||
| settings, and then when printing specify a tray | |
| other than "Auto Select" in "Paper Source" in the | |
| "Paper" tab of the printer driver setup screen. |
6 Click the "OK" button in the "Set Tray Status" window.
7 Click the "OK" button in the printer properties window.
11
