Sharp AR-M160, AR-M205 setup guide When the Finish screen appears, click the Close button

INSTALLING THE SOFTWARE

7 The files required for installation of the MFP driver are copied (if "MFP Driver" was selected in Step 5).

Follow the on-screen instructions.

When you are asked how the printer is connected, select "Connected to this computer" and click the "Next" button.

Caution	If the following screen appears while the files are
	being copied (the message may appear more
	than once), click the "Continue Anyway" button.

When "The MFP driver installation is complete." appears, click the "OK" button.

The Button Manager installer will start.

8 Begin the installation of Button Manager (if "Button Manager" was selected in Step 5).

Follow the on-screen instructions.

Click the "Finish" button when the message informs you that setup is successful.

The Sharpdesk installer will start.

9 Begin the installation of Sharpdesk (if "Sharpdesk" was selected in Step 5).

Follow the on-screen instructions.

Click the "Finish" button when the message informs you that Setup is complete.

10 When the "Finish" screen appears, click the "Close" button.

When "Now connect the MFP interface cable to the PC." appears, click the "OK" button.

After the installation, a message prompting Note you to restart your computer may appear. In

this case, click the "Yes" button to restart your computer.

11 Connect the interface cable to the machine and your computer (p. 10).

•If you are using a USB cable, make sure the machine's power is turned on and then connect the cable.

•If you are using a parallel cable, turn off the power of the machine and your computer, connect the cable, turn on the power of the machine, and then turn on your computer.

Windows will detect the machine and the Plug and Play screen will appear.

If you are using Windows XP with a parallel cable, go to step 13.

Caution	If the following message appears on your
	computer screen, close it.

A window regarding "HI-SPEED USB Device" will then appear. Close the window.

This message appears when the machine's USB 2.0 mode is not set to "Hi-Speed". For information on switching the USB 2.0 mode, see Chapter 4, "PRINTER/SCANNER FUNCTIONS", in the Operation Manual.

12 Begin installation of the scanner driver. (Only when using a USB cable.)

"SHARP AR-XXXX" will appear in the "Found New Hardware Wizard" dialog box. Select "Install the software automatically (Recommended)", click the "Next" button, and follow the on-screen instructions.

Caution	If a warning window appears regarding the
	"Windows logo test", be sure to click the
	"Continue Anyway" button.

13 Begin installation of the printer driver.

"SHARP AR-XXXX" will appear in the "Found New Hardware Wizard" dialog box. Select "Install the software automatically (Recommended)" and click the "Next" button. Follow the on-screen instructions.

Caution	If a warning window appears regarding the
	"Windows logo test", be sure to click the
	"Continue Anyway" button.

If the dual function board is installed, the Note "AR-XXXX (EB)" printer driver and scanner

driver will be installed.

This completes the installation of the software.

•If you installed the MFP driver, configure the printer driver settings as explained in "CONFIGURING THE PRINTER DRIVER" (p. 11).

•If you installed Button Manager, set up Button Manager as explained in "SETTING UP BUTTON MANAGER" (p. 12).

5