Before you start

Functional overview (cont’d)

Installing batteries in the remote control

Install two AA (R6) size batteries (supplied) into the remote control, carefully match with the polarity indicated inside the battery compartment.

1

2

3

Caution

Incorrect use of batteries can result in hazards such as leakage and bursting.

Do not mix new and old batteries together.

Do not use different kinds of batteries together.

Make sure that the plus and minus ends of each battery match the indications inside the battery compartment.

Remove batteries if the equipment will not be used for a month or more.

When disposing used batteries, please comply with governmental regulations or the public instructions for environmental protection that apply in your country or area.

Do not recharge, short-circuit, heat, burn or disassemble batteries.

Comply with the rules (ordinance) of each local government when disposing of worn-out batteries.

10 EN

About the remote control

Make sure there is no obstacle between the remote control and the remote control sensor on the unit.

Use within the operating range and angle as shown.

The maximum operable range as follows:

DV-RW370

 

OPEN/CLOSE

 

 

 

STOP/EJECT

PLAY

 

VCR

STOP

PLAY

OPERATE

 

 

DVD

 

REW F.FWD

REC/OTR

 

 

 

REC/OTR

 

PROGRAMME

 

 

 

 

 

(TRACKING)

DUBBING

OUTPUT SELECT

 

OPERATE

OPEN/CLOSE

 

 

DUBBING SETUP EJECT

 

T-SET

TIMER PROG. REC MODE RAPID PLAY

 

Line of sight:

 

approximately 7m

Either side of centre:

approximately 5m

Above:

 

within 30 degrees

 

approximately 5m

Below:

 

within 15 degrees

 

approximately 3m

 

 

within 30 degrees

Remote control operation may become unreliable if the remote control sensor of the unit is being exposed by the strong sunlight or fluorescent light.

Remote controls for different devices can interfere with each other. Be careful when using remote controls for other equipment located close to the unit.

Replace the batteries when the operating range of the remote control reduces.

Child Lock function

This function protects any unexpected operations by the kids when recording important programme and so on.

1

Press and hold [RETURN / ] for more than 5 seconds.

“LOC” will be displayed on the front panel display and the Child lock is now activated.

If any buttons (except for [RETURN / ]) on the remote control or the unit are pressed, “” will appears on the TV screen.

2

Press [RETURN / ] again for more than 5 seconds.

“LOC” disappears and the Child lock will be released.

Note

When One-touch Timer Recording or Timer Recording has finished or if the power failure occurs during Child lock is activated, the function will be released.

Page 10
Image 10
Sharp DV-RW370X operation manual Installing batteries in the remote control, About the remote control, Child Lock function