Sharp DV-RW370X Video setting cont’d, TV System Default PAL Set the TV system, Within 15 seconds

Changing the Setup menu

TV System (Default: PAL) Set the TV system.

	Video		DVD
Still Mode		Auto
TV System		PAL
Video Out		SCART(RGB)

Video setting (cont’d)

Video - TV System	DVD
PAL
Auto

Select the desired system set- ting using [Cursor K / L], then press [ENTER].

Note

PAL:	Outputs a modified PAL signal for viewing discs recorded
	with the NTSC system on a PAL system TV.
Auto:	Changes the video system (PAL / NTSC) automatically
	according to the format of the inserted disc.

Video Out (Default: SCART(RGB))

Sets the video output signal to be fixed accordingly to your TV set.

	Video		DVD	Video - Video Out	DVD
Still Mode		Auto
				SCART(RGB)
TV System		PAL		Component Progressive (P)
Video Out		SCART(RGB)		Component Interlace (I)

Refer to page 15 for more details.

If you select “SCART (RGB)” or “Component Interlace (I)”, proceed to step 5.

SCART(RGB):

Select “SCART(RGB)” if your TV has a scart terminal and connected to it.

Component Progressive (P):

If your TV is compatible with progressive scanning, select “Component Progressive (P)” and make sure the connection indicated by each jacks (Y / PB / PR) properly.

	Video - Video Out			DVD	Video - Video Out	DVD
Activating progressive scan:
Check your TV has progressive scan
and connect with component video cable.					Confirm again to use progressive scan.
NOTE: If there is no picture or picture is					If Picture is good, Select “Yes”.
	distorted after selecting “Yes”,				Yes
	Wait about 15 seconds for auto recovery.
					No
	Activate?	Yes	No

•With discs recorded using the PAL system, a PAL signal is output for viewing on a PAL system TV.

•Discs recorded with the PAL system cannot be viewed on an NTSC system TV.

•With discs recorded using the NTSC system, an NTSC signal is output for viewing on an NTSC or Multi system TV.

•With discs recorded using the NTSC system, select PAL to view on a PAL system TV.

Select the desired setting using [Cursor K / L], then press [ENTER].

Note

•When changing the Video Out setting (SCART(RGB), Component Interlace (I) or Component Progressive (P)), connect to a VIDEO jack or an S-VIDEO jack on the TV. If the setting is changed, for example, to SCART(RGB) while the COMPONENT VIDEO OUT jacks are used to connect

to the TV, a distorted video signal may be output.

•When “Component Progressive (P)” is selected, “P.SCAN” will appear on the front panel display.

Select “Yes” using [Cursor	Select “Yes” using [Cursor
s / B], then press [ENTER].	K / L], then press [ENTER]
	within 15 seconds.

Component Interlace (I):

If your TV that have component jacks, select “Component Interlace (I)” and make sure the connection indicated by each jacks (Y / CB / CR) properly.

5

Press [SETUP] to exit.

OPERATE	OPEN/CLOSE
DUBBING SETUP	EJECT

T-SET	TIMER PROG. REC MODE		RAPID PLAY	5
ZOOM	VCR	DVD	CM SKIP

84 EN