Changing the Setup menu

Audio setting (cont’d)

PCM sampling (Default : 48kHz)

 

 

Digital Out - PCM

 

 

 

 

DVD

 

 

 

48kHz

 

 

 

 

96kHz

 

 

 

 

 

 

 

 

 

 

 

 

Select a setting using [Cursor K / L], then press [ENTER].

Your setting is activated.

48kHz: If your amplifier / decoder is NOT compatible with 96kHz PCM, select “48kHz”. Sound recorded at 96kHz is down sampled to 48kHz.

96kHz: If your amplifier / decoder is compatible with 96kHz PCM, select “96kHz”. Sound is sampled at 96kHz.

Note

When playing back a disc with copyright protection or virtual surround system on this unit is set to “ON”:

• Even if you select “96kHz”, the sound is down sampled to 48kHz.

Dolby Digital conversion (Default : Stream)

 

 

 

 

 

 

 

Digital Out - Dolby Digital

DVD

 

 

 

 

 

 

 

 

PCM

 

 

 

 

Stream

 

 

 

 

 

 

 

 

 

 

 

 

Select a setting using [Cursor K / L], then press [ENTER].

Your setting is activated.

PCM:

Converts the Dolby Digital into PCM (2 channel).

 

If your amplifier / decoder is NOT compatible with Dolby

 

Digital, set to “PCM”.

Stream:

Outputs Dolby Digital signals.

 

If your amplifier / decoder is compatible with Dolby Digital, set

 

to “Stream”.

Note

When playing back a DVD-RW disc recorded in VR mode:

If the audio source on a disc is in Dolby Digital format, set “Dolby Digital” to “PCM” so that you can switch to main audio (L), sub audio (R), or a combination of both (L / R) using your amplifier / decoder.

Settings for MPEG (Default : PCM)

 

 

 

 

 

 

 

Digital Out - MPEG

DVD

 

 

 

 

 

 

 

 

PCM

 

 

 

 

Stream

 

 

 

 

 

 

 

 

 

 

 

 

Select a setting using [Cursor K / L], then press [ENTER].

Your setting is activated.

PCM: Converts MPEG into PCM.

If your amplifier / decoder is NOT compatible with MPEG, set to “PCM”.

Stream: Outputs MPEG Audio signals.

If your amplifier / decoder is compatible with MPEG, set to “Stream”.

Settings for DTS (Default : OFF)

 

 

 

 

 

 

 

Digital Out - DTS

DVD

 

 

 

 

 

 

 

 

ON

 

 

 

 

OFF

 

 

 

 

 

 

 

 

 

 

 

 

Select a setting using [Cursor K / L], then press [ENTER].

Your setting is activated.

ON:

Outputs DTS signals.

 

If your amplifier / decoder is compatible with DTS, set to “ON”.

OFF:

No DTS signal is output.

 

If your amplifier / decoder is NOT compatible with DTS, set to

 

“OFF”.

82 EN

Page 82
Image 82
Sharp DV-RW370X operation manual Audio setting cont’d, Select a setting using Cursor K / L, then press Enter