Sharp F0-50 F0-70 operation manual Replacing the thermal paper, FO-20PRw Thermal Paper 30 m roll

Loading the Thermal Paper

8 Close the operation panel, making sure it clicks into place.

• FO-50:A short length of the paper

will feed out. Grasp the paper by the edge and pull upward to tear it off.

Click!

•FO-70:A short length of the paper will be cut off.

Replacing the thermal paper

When the paper runs out, OUT OF PAPER will appear in the display. Reception and copying will no longer be possible. To replace the paper, first take out the old roll, then load the new roll as described above.

To assure a long life for your fax and obtain the best reproduction quality, we recommend that you use the following Sharp thermal paper, which is available from your dealer or retailer:

FO-20PRw THERMAL PAPER (30 m roll)

The use of any other paper may result in poor copy quality and excessive build-up of residue on the head.

Handling thermal paper

Do not unpack the paper until you are ready to use it. It may become discoloured if:

♦It is stored at high humidity or high temperature.

♦It is exposed to direct sunlight.

♦It comes in contact with glue, thinner, or a freshly copied blueprint.

♦A rubber eraser or adhesive tape is used on it, or it is scratched.

1. Installation

23