Sharp FP-N40CX operation manual Auto, Clean, Ion Control, Off

	Operations available with
	the Remote Control
	• AUTO
	• MANUAL
	• POLLEN
	• OFF TIMER
REMOTE CONTROL OPERATION
	• DISPLAY ON/OFF

• When you press the POWER ON/OFF Button, a short	Plasmacluster Ion mode
	selections
beep will sound and operation will start. As the initial	• AUTO
operation mode, it automatically goes to the AUTO (Fan
	• CLEAN
level) and AUTO Plasmacluster Ion Mode.
	• ION CONTROL
• To stop operation, press the POWER ON/OFF Button again.	• OFF
A long beep will sound and operation will stop.

POWER ON/OFF Button			Transmitter
Used to start AUTO operation			Filter Reset Button
of the unit. A short beep will	POWER ON/OFF	FILTER RESET	When you have cleaned the
signal that the unit is on and			Washable Active Carbon Filter
a long beep means that the	Fan Control		and re-inserted into the main unit,
unit is off.			press the Filter Reset Button with
		OFF￿
Auto (Fan Level) Button	AUTO MANUAL POLLEN TIMER		an instrument with a point such as
			a pen.
The fan level switches auto-			Pollen Mode Operation Button
matically depending on the		DISPLAY￿
amount of impurities in the air.			The unit operates effectively when
		ON/OFF
Manual (Fan Level) Button			you suspect there is pollen in the
			air. See Page E-12
The fan level can be switched			Off Timer Button
between Silent, Medium,	Plasmacluster
High and Max.	CLEAN		Used to set the Off Timer.
Display ON/OFF Button			The set time switches every time
	AUTO	OFF	the button is pressed as shown
Switches the Plasmacluster			below.
Indicator Light and CLEAN-	IONCONTROL
				1 hour	4 hours
SIGN Light either ON or OFF.
• The Plasmacluster Indicator
				Cancel	8 hours
Light is turned on for about
			• The indicator light shows the re-
3 seconds by pressing the
Plasmacluster Ion Select			maining time.
Button (except for the OFF			• The unit will cease operating
Button) during “Display			when the timer is up.
OFF” mode.

Plasmacluster Ion mode Selections

ENGLISH

Auto

When pressed, the unit will switch between Clean Mode and the Ion Control Mode auto- matically depending on the amount of impuri- ties in the air as detected by the odor sensor. Clean Mode will operate for about 1 minute when the Auto function is selected.

Clean

When pressed, the unit will con- stantly operate in the Clean Mode, in which the same numbers of posi- tive and negative ions are dis- charged. (The Plasmacluster Indi- cator Light is blue.)

Ion Control

When pressed, the unit will constantly oper- ate in Ion Control Mode.

Ion balance is maintained in the room envi- ronment by increasing the ratio of negative ions. (The Plasmacluster Indicator Light is green)

Off

The generation of ions will cease and the Plasmacluster Indicator Light will go out.

If the room is damp or has a mold problem, operate the unit in Clean Mode.

E-13