Sharp LC-37HV4M operation manual Simple button operations for changing channels, Channel display

Watching TV

Simple button operations for changing channels

You can change channels in several ways.

Using CHa/bon the remote control unit

•Press CHato increase channel number.

•Press CHbto decrease channel number.

NOTE

•CHs/ron the Display operates the same as CHb/aon the remote control unit.

CHs/r

Using 0 – 9 on the remote control unit

Select the channels directly by pressing buttons 0 to 9.

a

To select a 1-digit channel (e.g. channel 2):

•Press 2. If “2” is indicated and the picture does not change, press oto switch over to the 1-digit select mode and press 2 again.

To select a 2-digit channel (e.g. channel 12):

•Press o to set the 2-digit select mode. Press 1, followed by 2.

NOTE

•Complete this procedure within 3 seconds, otherwise the selection will not be made on the 2-digit channel mode.

When viewing Teletext information

View a page directly which is 3-digit page number from 100 to 899 by pressing buttons 0 to 9. With Teletext, you do not use o. (See page 64).

Channel display

Channel display changes approximately after 3 seconds as shown below.

SAT.1

12

PAL

B/G

(Example)

SAT.1

12

MONO

Using Flashback (A) on the remote control unit

Press A to switch the currently tuned channel to the previously tuned channel.

Press A again to switch back to the currently tuned channel.

17