Sharp LC-46GD7X, LC-52GD7X operation manual Setting the TV on the wall, Removing the stand

Preparation

Setting the TV on the wall

•You can mount the TV on the wall, using the optional AN-37AG2/AN-52AG1 bracket.

•For details, refer to the instructions supplied with the optional bracket.

CAUTION

•This TV should be mounted on the wall only with the AN-37AG2/AN-52AG1 (SHARP) wall mount bracket. The use of other wall mount brackets may result in an unstable installation and may cause serious injuries.

•Installing the Liquid Crystal Television requires special skill that should only be performed by qualified service personnel. Customers should not attempt to do the work themselves. SHARP bears no responsibility for improper mounting or mounting that results in accident or injury.

Using an optional bracket to mount the TV

•You can ask a qualified service personnel about using an optional AN-37AG2/AN-52AG1 bracket to mount the TV to the wall.

•Carefully read the instructions that come with the bracket before beginning work.

Hanging on the wall

AN-37AG2/AN-52AG1 wall mount bracket. (See the bracket instructions for details.)

Vertical mounting Angular mounting

NOTE

About setting the TV angle and height adjustment

0˚ For AN-52AG1

10°/5°/10°/15°/20° for LC-46GD7X (0°/5°/10°/15° for LC-52GD7X)

2-5/0/+5 cm (can be moved 5 cm up or down)

AN-37AG2 AN-52AG1

• Detach the cable clamps on the rear of the TV when using the optional mount bracket.

Removing the stand

For wall mounting with the optional bracket, remove the stand.

Before attaching/detaching the stand

•Before detaching (or attaching) the stand, unplug the AC cord from the AC outlet.

•Remove all terminal covers and connected cables.

•Make sure two or more people perform the operation.

CAUTION

• Do not remove the stand from the TV unless using an optional bracket to mount it.

1

2

Unfasten the four screws used to secure the stand in place.

Detach the stand from the TV.

(Hold the stand so it will not drop from the edge of the base area.)

NOTE

• To attach the stand, perform the above steps in reverse order.

7