Appendix
• Before detaching (or attaching) the stand, unplug the AC cord from the AC INPUT terminal.
Do not remove the standfrom the TVunless using an optionalwall mount bracket to mount it.
Before attaching/detaching the stand
,, Before performing work, make sure toturn off the TV.
Before performing work spread cushioning over the base area to lay the TV on. This will prevent itfrom being
damaged.
1
o
y--:: _} , _ c-- /
Unfasten the four screws used to secure the stand in
place.
2
Detach the stand from the TV. (Hold the stand so it
will not drop from the edge of the base area.)
To attach the stand, perform the above steps in reverse order.
LC=40LET00UN
This TV should be mounted on the wall with both the AN=37AG2 (SHARP} wall mount bracket and the AN=37P30
(SHARP} attachment of the wall mount bracket. The TV cannot be mounted when with only the AN-37AG2 wall
mount bracket. The use ofother wall mount brackets may result inan unstable installation and may cause
serious injuries.
LC=46LET00UN/LC=52LET00U N
This TV should be mounted on the wall only with the wall mount bracket AN-52AG4 (SHARP}. The use of other
wall mount brackets may result in an unstable installation and may cause serious injuries.
Installing the TV requires special skill that should only be performed by qualified service personnel. Customers
should not attempt to do the work themselves. SHARP bears no responsibility for improper mounting or
mounting that results in accident or injury.
Using an optional bracket to mount the TV
You canask a qualified service professional about usingan optional AN-37AG2 or AN-52AG4 bracket to mount the
TVon the wall.
Carefully read theinstructions that come with the bracket before beginning work.

Hanging on the wall

AN-37AG2 or AN-52AG4 wall mount bracket.
(See the bracket instructions for details.)
About setting the TV angJe
AN-37AG2 +AN-37P30
0js/_0/_s/20o LC=40LET00UN
•The center of the display:
19/e4inches (29.05 mm) under the "B" position.
AN-52AG4
LC=46LET00U N
•The center of the display:
_/_6inch(1,2 mm) under the "b" position.
LC=52LET00U N
•The center of the display:
Vertical mounting Angular mounting _/64inch(1.75 mm) underthe "b" position.
• Referto the operation manual of
AN-37AG2/AN-37P30 orAN-52AG4 for details.
Detach the cable clamp on the rearof the TVwhen using the optional mount bracket.
Dueto the terminal configuration on this TV, when you wall-mount this model, make sure there is enough space between the
wall and the TV for the cables.
To use this TV mounted on a wall, remove the covers at the 4 locations on the rear ofthe TV, and then use the screws
supplied with the wall mount bracket to secure the bracket to the rear ofthe TV. Q- 53