Manual Update
Select the method for manually updating the software.
USB Update: Updates the software using a USB memory device containing the update fi le. (See "Updating the Software with a USB Memory Device".)
Network Update: Downloads the update fi le via the network and then updates the software. (See page 29.)
NOTE
•You cannot update the software using a SD memory card containing the update fi le.
•A broadband connection and Internet Setup are required to update the software using the network. (See pages 43 to 44.)
•It may take time to access and download the update depending on the Internet connection and other factors.
■Updating the Software with a USB Memory
Device
To check for the availability of a software update, visit http://www.sharpusa.com/products/support/. If you have any questions, please
call
CAUTION
•Do not remove the USB memory device or unplug the AC cord while the software is being updated.
•Be sure to properly follow the whole procedure described below, step by step. Otherwise, for example, the TV cannot read the data in the USB memory device and software updating will fail.
1Insert the USB memory device with the update
file into the USB 1 or USB 2 terminal on the TV.
•When you update the software, use only one USB terminal. Either USB 1 or USB 2 is usable.
or
2Press a/b on the Manual Update screen to select "USB Update", and then press ENTER.
3Press ENTER to start checking the data in the USB memory device.
Insert the USB memory device containing the software update file.
OK
4During the data checking, "Checking" blinks.
Now checking the data in the USB memory device.
Checking
•The current version of the TV software and the version of the update fi le on the USB memory device are displayed.
Example
Software update file is detected in the USB memory device.
Start update?
Current Version | : UXXXXXX1 | ||
Update Version | : UXXXXXX2 | ||
|
|
|
|
Yes |
|
| No |
|
|
|
|
•If the USB memory device is not properly installed or the correct update fi le cannot be found on the USB memory device, an error message is displayed.
Check the fi le on the USB memory device, and then reinsert the USB memory device correctly.
Software update file is not detected in the USB memory device.
Confirm that you have transferred the file
to the USB memory device and retry software update.
OK
There is more than one software file in the USB memory device. Confirm that only the software update file is
in the USB memory device.
OK
5To update the TV software with the update fi le, select "Yes", and then press ENTER.
Software update file is detected in the USB memory device.
Start update?
Current Version | : UXXXXXX1 | ||
Update Version | : UXXXXXX2 | ||
|
|
|
|
Yes |
|
| No |
|
|
|
|
Example
Now updating
Update Version | : UXXXXXX2 |
30%
Remote Control operation is disabled during updating process.
Do not unplug AC cord.
CAUTION
•Do not remove the USB memory device or unplug the AC cord while the software is being updated.
6When the software is successfully updated, a screen is displayed indicating that the update process is completed.
After this screen is displayed, the TV automatically turns off and then turns on again.
Example
Software Update is complete.
Update Version | : UXXXXXX2 |
OK
•If the update has failed, check the fi le in the USB memory device and try Software Update again.
Failed to complete update.
Retry Software Update.
If system update fails again,
contact the customer service center.
Update Version | : UXXXXXX2 |
OK
7After the screen shown below is displayed, press
ENTER.
System software has been
updated successfully.
Remove the USB memory device.
Update Version: UXXXXXX2
OK
8Remove the USB memory device.
28
