Connecting the TV to a computer

CAUTION!

-When connecting, ensure that the TV and all the equipment you are connecting to it are switched off.

-Be careful not to over bend the cable or add extension cords as this could lead to a malfunction.

Notes:

-When using the TV with an analog connection, perform an automatic screen adjustment (page

E46) under the following conditions:

-Using the TV for the first time.

-After having changed the system settings during use.

-When using the TV with a digital connection, automatic screen adjustment is unnecessary.

-When connecting to a notebook computer and the notebook computer's screen is set so that it is displaying at the same time, the MS-DOS screen may not be able to display properly.

In this case, change the settings so that only the TV is displaying.

Installing the set-up information

Depending on the computer or OS, you may have to install the set-up information for the TV. Refer to "readmee.pdf" (in English) on the supplied CD-ROM. You need Adobe Reader installed on your computer to view this PDF file.

Analog connection

Connect the supplied PC analog signal cable to the analog RGB output terminal of the computer. See page E10 for information on removing/ replacing the terminal cover.

PC analog RGB input terminal (Mini D-sub 15 pin, 3 rows)

Computer

Analog RGB

output terminal (Mini D-sub 15 pin, 3 rows)

PC analog signal cable (supplied)

-Paying attention to the connector direction, firmly insert the signal cable straight into the connector, and then tighten the screws at both ends.

If connecting to a D-sub 15 pin 2 row Apple Power Macintosh, attach a Macintosh conversion adapter (commercially available) to the analog signal cable.

Power Macintosh

English Español Italiano Español Français English

Macintosh conversion adapter

E25