Instructions for attaching a VESA-compliant mount

An arm or stand based on the VESA standard (commercially available) can be attached to the TV. Procurement of the arm or stand is at the customer's discretion.

Arms or stands able to be used

Attachments must satisfy the following.

-Compatible with the VESA standard.

-The six screw holes on the section to be attached have a gap of 100 mm between them.

-Not be likely to fall off or break off after being attached to the TV.

How to attach the arm or stand

-Be careful not to over bend the cable or add extension cords as this could lead to a malfunction.

-While following these instructions, please also refer to the installation instructions in the operation manual included with the arm or stand.

-Because the TV is heavy, we recommend that you perform the operation with two or more persons including yourself.

CAUTION!

-Be careful not to get your fingers pinched between the display and stand nor to let the stand drop. These could lead to injury.

-Do not cover or block ventilation openings since insufficient ventilation can cause overheating.

1.Turn off the TV power using the POWER button on the TV.

2.Remove the terminal covers and the cables. See page E10 for information on removing the terminal cover.

3.Spread out a soft cloth on a flat surface. Being careful not to damage the TV, gently lay the TV on it display-side down.

4.Remove the two screws and then remove the rear cover of the stand.

Soft cloth

5.Remove the four screws and then remove the stand from the TV.

Notes:

-If the stand is hard to remove, pull it toward you while holding it up slightly.

-The stand is specially made for use with this TV. Once having removed the stand, never attempt to attach it to another equipment.

-Once having removed the screws, store them together with the stand. If the stand is ever re- attached, be sure to use the original screws.

Using different screws could lead to a malfunction.

6.Attach the arm to the TV with the six screws.

Note:

-The screws used to attach the arm should be M4 screws with a length of 10 mm protruding from the surface to be attached.

Using different screws could cause the TV to fall off or to be internally damaged.

10 mm

Screw used to attach arm

Arm

Part of TV to which arm is attached

E60