Sharp LL-H1813 Connecting the monitor and turning the monitor on and off, Analog RGB connection

Connecting the monitor and turning the monitor on and off

Connecting the monitor to a computer

Analog RGB connection

Connect the accessory analog signal cable or the analog signal cable (sold separately-model name: NL-C02E) to the DVI-I input terminal of the monitor and analog RGB output terminal of the computer.

Input terminal 1 and 2 ( You can connect to either side )

Analog signal cable	Analog RGB output
	terminal

-Paying attention to connector direction, firmly insert the signal cable to terminal, and then tighten the screws at both sides.

If connecting to a D-sub 15 pin 2 row Apple Power Macintosh, attach a Macintosh conversion adapter (commercially available) to the analog signal cable.

Macintosh conversion adapter

Digital RGB connection

Connect the digital signal cable (sold separately- model name: NL-C01E) to the DVI-I input terminal of the monitor and digital RGB output terminal of the computer.

-For a digital signal input, it can be connected to a computer with a DVI-compatible output terminal (DVI-D24 pin or DVI-I29 pin) and which has SXGA output ability. (Depending on the computer to be connected, correct display may or may not be possible.)

Input terminal 1 and 2 ( You can connect to either side )

Digital signal cable	Digital RGB output
	terminal

-Paying attention to connector direction, firmly insert the signal cable to terminal, and then tighten the screws at both sides.

Set the monitor as follows when establishing a digital connection with a Power Mac using an ADC- DVI adapter made by Belkin. (Operation has been checked with the Power Mac G4 M7627J/A)

-Perform settings with the Power Mac power supply off.

1.After connecting the power cord, turn on the monitor’s main power.

2.Press the button and button simultaneously, and while doing this press the POWER button (i.e. turn the power on).

3.Set the input terminal to which the Belkin ADC- DVI adapter is connected to ON.

Use the SELECT button to select [INPUT1] or

[INPUT2], and use the buttons to select [ON] and [OFF].

-Do not set to [ON] if you are not using a Belkin ADC-DVI adapter, as this may result in incorrect display.

4.Press the MENU button. This completes setting.

English

13