Sharp LL-H1813 operation manual Adjusting the screen display When using a digital signal

Adjusting the screen display (When using a digital signal)

Adjustments can be made using On Screen Display (OSD) Menu provided.

On Screen Display for adjustment

If you are using Windows, open the Adjustment Pattern on the accompanying CD-ROM. (p. 17)

If your system is not Windows, you can not use the Adjustment Pattern. Therefore display an image that makes the entire screen light and adjust it through checking visually its actual tone.

This chapter provides the procedure how to adjust the screen by using Adjustment Pattern (for Windows)

How to adjust

1.Press the MENU button.

The COLOR CONTROL Menu will be displayed.

COLOR CONTROL
	sRGB		VIVID
COLOR MODE		STD
WHITE BALANCE
HUE	0
SATURATION	0
INPUT-2 DIGITAL
1280 x 1024	V : 60Hz	H : 64kHz

At this point relevant menu options can be adjusted.

Each time the MENU button is pressed the next menu is selected. (COLOR CONTROL → MODE SELECT → OSD Menu disappears)

Notes:

-The OSD Menu automatically disappears approximately 30 seconds after the last command.

COLOR CONTROL Menu

COLOR CONTROL
	sRGB		VIVID
COLOR MODE		STD
WHITE BALANCE
HUE	0
SATURATION	0
INPUT-2 DIGITAL
1280 x 1024	V : 60Hz	H : 64kHz

Notes:

-To choose a menu option: SELECT button

-To go to the next menu: MENU button

COLOR MODE

Color tone can be set as below.

sRGB : sRGB is international standard of color representation specified by IEC (International Electrotechnical Commis- sion). Color conversion is made in taking account of liquid crystal’s characteristics and represents color tone close to it original image.

STD : Displays image with the color tone results from original scheme of liquid crystal panel.

VIVID : Displays an image with dynamic and VIVID primary colors.

-If [sRGB] or [VIVID] has been selected, items subsequent to [WHITE BALANCE] cannot be set.

Subsequent items can be set when the [COLOR MODE] is [STD].

WHITE BALANCE

After selecting [WHITE BALANCE], press the button and display the adjustment menu.

WHITE BALANCE

COOL STD WARM USER

R-CONTRAST

G-CONTRAST

B-CONTRAST

English

OK < MENU >

Notes:

-On settings other than [STD] not all graduations can be displayed. To display all graduations, set to [STD].

-Use the buttons to select [COOL], [·], [STD], [·], [WARM] or [USER].

-Selecting USER will display the setting values for [R-CONTRAST], [G-CONTRAST] and [B- CONTRAST], in order to make fine adjustments.

-Use the SELECT button to select [R-CONTRAST], [G-CONTRAST] and [B-CONTRAST].

-When adjustment complete: MENU button

21