Connecting the monitor and turning the monitor on and off
CAUTION!
-When connecting, ensure that both the monitor and computer are switched off.
-Be careful not to overly bend the cable or add extension cords as this could lead to a malfunction.
Cable storage
If necessary, excess cable can be housed in the stand.
1.Remove the cover.
Gently pull the top of the cover towards yourself.
2.Run cable along the back of the stand.
Pass cable in front of the stand, and then bring it through the back.
3.Refit the cover.
Be careful not to pinch the cable.
-If the cover is hard to refit, do not force it. Check whether cables are trapped.
CAUTION!
-If the display is to be rotated, first house the cable, and then check while gently turning the display. If it cannot be turned, rehouse the cable with sufficient slack. (If there is insufficient cable length, rotation will be impossible. Forcing rotation may cause cable disconnection.)
Connecting the monitor to a computer
Connecting using accessory analog signal cable
Connect the accessory analog signal cable to the analog RGB input terminal of the display, and the analog RGB output terminal of the computer.
Analog RGB input terminal
English
- If the display is to be rotated, first house the cables with the display in the long height position, so there is sufficient length when the display is turned.
Analog signal cable | Analog RGB output |
| terminal |
- Paying attention to connector direction, firmly insert the signal cable to terminal, and then tighten the screws at both sides.
11
