Instructions for attaching a VESA compliant arm
An arm or stand based on the VESA standard (purchased separately) can be attached to the monitor.
Procurement of the arm or stand is at the custom- er's discretion.
Arms or stands able to be used Attachments must satisfy the following.
-Compatible with the VESA standard
-Have a gap of at least 100 mm x 100 mm between the screw holes on the section to be attached
-Not be likely to fall off or break off after being attached to the monitor.
How to attach the arm or stand
Note:
-While following these instructions, please also refer to the installation instructions in the operation manual included with the arm or stand
-Do not overly bend the cable or add extension cords as this could lead to malfunction.
1.Spread out a soft cloth on a suitable horizontal surface.
2.Being careful not to damage the monitor, gently lay the monitor on it
3. Remove the stand cover.
(Rear view) | Stand cover | |||||
|
|
|
|
|
|
|
Lift one side
5.Remove the four screws and then remove the stand from the monitor.
Four screws
Stand
6.Attach the arm to the monitor with the four screws.
The screws used to attach the arm should be M4 screws with a length of 8 mm ~ 10 mm protruding from the surface to be attached.
Using any other kind of screw may lead to the monitor falling off or damage to the internal part of the monitor
Screw used to attach arm Arm
Part of monitor to which arm is attached
4. Remove the two screws, and remove the cover.
Cover
Two screws
25
