To turn off the power:

Press the /:OFF button whilst in the stop mode.

After the track number has been written on the disc, the power will shut off automatically.

(For details about the TOC, see page 21.)

To remove the MiniDisc:

Turn off the power and move the OPEN le- ver in the direction indicated by the arrow.

2

1

OPEN

Recording from a tuner or a CD (Manual recording)

Manual recordings can be started and stopped as you like.

1 Place the unit in the recording stand-by mode.

(Perform steps 1 - 4 in the “Synchro recording” section.)

2 Press the 06 button.

Recording will start.

To record from a CD, press the 06 button, and then start playback on the equipment connected to this unit.

Track numbers can be created whilst recording. (Page 18)

To interrupt recording:

Press the 06 button whilst recording.

The unit will enter the recording stand-by mode.

To resume recording, press the 06 button again.

The track number will be increased by one each time you interrupt a recording.

Recordings can not be made in the following situations:

Recording on a playback-only MiniDisc (commercially available music).

If a MiniDisc is protected against accidental erasure. (page 10)

About the recording level:

If the recording level is too low, the playback sound volume may be too low to hear well. If it is too high, the playback sound may be greatly distorted. Since digitally recorded CDs have a large dynamic range (the volume can vary tremendously from very soft to extremely loud), do not set the recording level any higher than is necessary.

Precautions when recording:

Do not jar or bump the main unit whilst recording. Otherwise, the recording may be unusable.

Depending on the strength and type of playback signal in the original recording, the new recording may not begin or pause at the correct point when in the synchro mode.

If this happens, try making a manual recording.

Precautions when inserting a MiniDisc:

To insert a MiniDisc, push on the middle of the edge of the disc whilst holding it parallel to the main unit.

If any resistance is felt, do not try to force the MiniDisc into the unit, as it may cause damage to the unit. If resistance is felt, remove the MiniDisc and try reloading it.

12

* MD-MT16H FOR UK(01-21)

13

99.4.2, 0:57 PM

Page 13
Image 13
Sharp MD-MT16H To turn off the power, To remove the MiniDisc, Recording from a tuner or a CD Manual recording