Sharp operation manual MD-MT16H for UK22-42 99.4.2, 055 PM

2 When the recording is complete, remove the newly recorded MiniDisc and load the master MiniDisc into the MD-MT16E.

●Do not mistake the master MiniDisc for the newly recorded MiniDisc.

3 Whilst in the stop mode, press the EDIT button to select “NAME STAMP”.

4 Press the ENTER/SYNC button.

●To cancel the operation, press the ■/:OFF button.

34

5 Press the ENTER/SYNC button.

●The character information of the master MiniDisc is being read.

6 When the unit displays “CHANGE MD”, remove the master MiniDisc.

●Remove the master MiniDisc without turning off the power. If you do, the operation will be cancelled.

8 Press the ENTER/SYNC button.

●The unit will finish recording the char- acter information and enter the stop mode.

Note:

●If the total number of tracks on the mas- ter MiniDisc does not match the total number of tracks on the newly recorded MiniDisc, the unit will display “Can’t WRITE” and the power will be turned off. If this happens, adjust the total number of tracks on the newly recorded MiniDisc using the edit operation, and then try again from step 2.

56

7 Load the newly recorded MiniDisc into the MD-MT16E.

●To cancel the operation, press the ■/:OFF button.

32

* MD-MT16H FOR UK(22-42) 33 99.4.2, 0:55 PM