68
Alarm display of the inserter

When the indicators are lit and/or blinking as shown below, operation will not take place even if you press the [START]

key ( ). Solve the problem according to the combination of the indicators that are lit and/or blinking.

[PUNCH]

indicator [STAPLE] indicator [START]

indicator Cause Solution

Any one of the indicators is solidly lit. Blinks red
A paper size that cannot be
fed has been loaded.
For the paper sizes that can
be used for punching,
stapling, or pamphlet
stapling, see
"SPECIFICATIONS" in this
operation manual.
Blinking – – – – Blinks red
The hole punch scrap
container in the punch
module on the finisher or
saddle stitch finisher is full.
Dispose of punch scraps.
☞"PUNCH MODULE" in
the User's Guide
Any one of the indicators is blinking. –Blinks red The finisher or saddle stitch
finisher tray is full.
Remove the paper from the
tray.
–Any one of the
indicators is blinking. –Blinks red
The finisher or saddle stitch
finisher is out of staples.
Replace the staple cartridge.
Do not forget to replace the
staple case.
☞"FINISHER / SADDLE
STITCH FINISHER
MAINTENANCE" in the
User's Guide
– – – –
Blinking
Blinks red
The saddle stitch tray on the
saddle stitch finisher is full.
Remove the paper from the
saddle stitch tray.
The saddle stitch finisher is
out of saddle stitch staples.
Replace the staple cartridge.
Do not forget to replace the
staple case.
☞"FINISHER / SADDLE
STITCH FINISHER
MAINTENANCE" in the
User's Guide
–Any one of the indicators is
blinking. –
Functions have been
disabled by the
administrator.
Some functions may have
been disabled in the system
settings (administrator).
Check with your
administrator.
Blinking – – – – –
The punch waste box is not
installed.
After disposing of punch
scraps, install the punch
waste box.
Functions have been
disabled by the
administrator.
Some functions may have
been disabled in the system
settings (administrator).
Check with your
administrator.