Sharp PG-D3550W, PG-D2870W, PG-D3050W Signal Adjustment “SIG-ADJ” Menu Continued, EDID Selection

Signal Adjustment (“SIG-ADJ” Menu) (Continued)

Menu operation n Page 40

5-1 EDID Selection

EDID (Extended Display Identification Data) is data that enables a computer to make proper display settings.

When you cannot find the desired resolution on your computer, switch EDID selection. If still unsuccessful, reboot the computer.

Selectable	Description
items
Standard	Standard setting.
Enhanced	When the desired resolution cannot
	be found in standard setting.

5-2 Setting the Video System

The video input system mode is factory preset to “Auto”; however, a clear picture from the connected audio-visual equipment may not be received, depending on the Video signal difference.

In that case, switch the Video signal.

Selectable items

Auto

PAL

SECAM

*NTSC4.43

NTSC3.58

PAL-M

PAL-N

PAL -60

*When reproducing NTSC signals in PAL video equipment.

Note

•The Video signal can only be set in S-VIDEO or VIDEO mode.

•When “Video System” is set to “Auto”, you may not receive a clear picture due to signal differences. Should this occur, switch to the video system of the source signal.

6 Setting the Video Setup

Selectable	Description
items
0 IRE	Sets the black level to 0 IRE.
7.5 IRE	Sets the black level to 7.5	IRE.

Note

•This function is available for the following signals.

With COMPUTER/COMPONENT 1 or 2 input: - 480I

With S-VIDEO or VIDEO input: - NTSC3.58

7 Checking the Input Signal

This function allows you to check the current input signal information.

46