3 Press ,  or  on the re- mote control to select the IN- PUT Mode.

3 Press ➝ INPUT 2 Mode, Manual background or Manual background on the re- mote control to select the IN- PUT Mode.

After pressing Manual backgroundManual background once, use the but- ton to select the desired INPUT Mode.

Manual background Note

When no signal is received, “NO SIGNAL” will be displayed. When a signal that the projector is not pre- set to receive is received, “NOT REG.” will be displayed.

About the INPUT Modes

INPUT 1

Used for projecting im-

(RGB/

ages from equipment that

Component)

sends RGB signals or

 

Component signals con-

 

nected to the DVI-DIGI-

 

TAL/ANALOG input port.

INPUT 2

Used for projecting im-

(S-Video)

ages

from equipment

 

connected to the S-

 

VIDEO input terminal.

INPUT 3

Used for projecting im-

(Video)

ages

from equipment

 

connected to the VIDEO

 

input terminal.

 

 

 

4 Press Manual background or Manual background on the remote control to adjust the volume of the speaker.

Manual background Note

Pressing Manual background will raise the volume.

Pressing Manual background will lower the volume.

On the projector, the volume can be

adjusted by pressing Manual background or Manual background .

Manual background , Manual background on the projector operate

as cursor buttons (Manual background, Manual background) when

selecting setup or adjustment functions while adjusting menus or the lens.

"On-screen Display (Example)

 

 

 

 

 

 

INPUT 1 Mode

 

 

 

 

Using

DVI digital

Using Analog

RGB

Using

Component

INPUT 2 Mode

Using S-Video

INPUT 3 Mode

Using Video

Manual background VOLUME Manual backgroundManual background buttons

Basic Operation

Manual background-29

Page 33
Image 33
Sharp PG-M20S operation manual INPUT 2 Mode, Press , or on the re- mote control to select the IN- PUT Mode, Basic Operation