Controlling the Monitor with a PC
nRepeater control
This system has a function to allow setting of multiple monitors connected in a daisy chain using a single command. This function is called repeater control. You can use Repeater control function without assigning ID numbers.
[Example]
Set 1 |
| Set 2 |
| Set 3 |
| Set 4 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Setting of the GAMMA user data
nTo transfer the GAMMA user data
Use the user data transfer commands (UGRW, UGGW and UGBW). For each of the R, G and B colors, divide the total 512 pieces of user data into 16 blocks, and transfer 32 pieces of data with each command.
C1 C2 C3 C4 P1 P2 P3 P4 … S1 S2
Command field Block number (01 to 16) Data field Checksum field
*If monitors are connected as shown above, you can execute a command like “Set all monitors’ input settings to
PC
nRepeater control command
Repeater control is achieved by setting the FOURTH CHARACTER of the parameter to “+”.
Example:
VOLM030 + | ← Sets volume of all monitors to 30. |
In repeater control, responses are returned by all the connected monitors.
If you want to determine that a value has been returned by a specific set, assign ID numbers to each monitor in advance. When some monitors do not return their responses, the probable cause is that the monitors could not receive the command or command processing is not complete. Do not send a new command.
Example: (When 4 monitors are connected, and assigned ID numbers: 1 through 4)
VOLM030 +
WAIT
OK 001
OK 002
OK 003
OK 004 ← If 4 monitors are connected in a chain, reliable operation can be ensured by sending a new command only after a reply has been returned by 4th (last) monitor.
Repeater control can also be used for reading settings.
Example: To transfer the data of block 1 (0 to 31 levels)
of red (R) data
UGRW01000000010002 … 0031C0
One piece of data consists
of 4 digits.
Command Block number 32 pieces of data | Checksum |
*If data is less than 4 digits, add a “0” (zero) to make it 4 digits.
*The checksum field is the character string (ASCII) data of
nSaving the GAMMA user data
Use the user data save command (UGSV) to save the transferred user data in the monitor.
If the data is not saved, it will be cleared when:
•The main power switch is off
•STANDBY MODE is LOW POWER and the monitor enters standby mode
nActivating the GAMMA user data
To activate the transferred user data, select USER for GAMMA of the PICTURE menu, or send the corresponding
nChecking the GAMMA user data
Use the user data read commands (UGRR, UGGR and UGBR) to return 512 pieces of user data for each of the R, G and B colors. Divide the data into 16 blocks and return 32 pieces of data with each command. The value to be returned is not the value stored in the monitor, but the value in the temporary memory for display. (These values are the same when the user data save command (UGSV) above has been sent.)
Example:
VOLM ? ? ? +
WAIT
10001
20002
30003
30004
Volume settings for all monitors are returned.
TIPS
•The user data is not initialized by RESET of the PICTURE menu. To initialize the user data, use ALL RESET of the FUNCTION menu.
The GAMMA user data initialize command (UGRS) allows the initialization of the user data only.
TIPS
•If repeater control is used during ID designation (IDSL, IDLK), the ID designation is canceled.
